Installation and operation
16 / 30
104304
EN
Indications for User
• If the appliance is installed in an area, where potable water features high salt
content, follow the instruction to avoid possible malfunctions.
• For the ice not to take up unpleasant scent nor taste, do not store food, bottles
nor anything else in the storage container.
• Do not leave the storage container lid open during normal operation.
Switching-On
1. Before switching on, check if water and power connections are executed
correctly.
2. Check if bands, screws, studs and clamps are securely tightened and did not
come loose during transportation to prevent water leaks or other malfunctions
during operation.
3. Open the water connection tap and the shut-off valve.
4. Plug the appliance into a single grounded socket.
The appliance is now in standby. The control key blinks every 30 seconds.
5. To leave the Standby mode and switch the appliance on, press the control key
for at least 3 seconds, and wait for a long acoustic signal, confirming the
appliance is on (Fig. 11).
NOTE!
We recommend not to use ice cubes from the first 5 production cycles to chill
beverages nor foods.
Never disconnect the water supply when the appliance operates; do not cover
nor clog the air outlet openings.
Check if water is supplied to the tank, if the sensor and/or float stop water flow
and prevent overflowing, and if there are no leakages in installations and water
pipes. Normal water level in the tank is approx. 5
–10 mm, counted from top
edges (Fig. 12).
Water level may be regulated by rotating the micro-float or water sensor through
the designated crevice, located on the right bracket, following screwing the fixing
screw 1 off (Fig. 12). This regulation must be performed with power supply
disconnected.
6. Make sure there are no strange vibrations generated by loose screws.
7. If an interference is required due to water leak, tightening of screws, etc., always
switch the appliance off first.
