Installation and operation
18 / 24
1054513
EN
•
Przed pier wsz ym uż yciem wycz yś cić urządz eni e i wypos ażenie zgodni e z e ws kazówkami z awartymi w
pu nkcie 6 „Cz yszczen ie”
. U waż ać, aby do ins tal acji elektr ycznej i s krz ynki roz dzi elcz ej ni e dostała si ę woda. N astępnie dokł adnie os usz yć urządz eni e i elementy wypos aż enia.
•
Ins ert t he bott om c over int o the applianc e. The c over acts as a spac er bet ween t he heating element and l ef t-over f ood tray.
•
Caref ull y i nser t t he c onnection box wit h the heati ng element at t he bac k edge of t he applianc e. A pin in bott om par t of t he c onnecti on box must ent er a hol e i n t he mai n applianc e. This way t he connec tion box is properly mount ed.
Appliance Start-up
Fig. 7
1. Open the gas shut-off valve at the gas supply tube.
2. Set the gas controller (10) to OFF marking (a).
3. Press the rotary controller (10).
4. Press and hold the rotary controller (10) and rotate it counter-clockwise.
This way the valve is opened and gas is delivered to the burner via the gas supply
tube.
5. Keep the gas controller (10) pressed and at the same time operate the
piezoelectric ignition button (11).
A loud clicking sound is heard, and the ignition spark ignites the gas at the burner.
6. When the flame is ignited, keep the gas controller (10) pressed for a few
seconds, until the thermal element heats up.
7. Release the rotary controller (10).
Should the flame go out, it will be recorded by ignition protection at the burner and
the gas supply will be interrupted.
8. Wait until the gas escapes and repeat the above steps.
Summary of Contents for 1054513
Page 1: ...G 1KB 1K680 1054513 ...
