Bartscher 132.115, Operation And Maintenance Manual

Pag.  6

2.2 SETTING

START-UP

-   Use main switch to start up.   

-   Turn the knob (Fig. 3) to set at the required 

temperature.  

FIELD OF OPERATION: +50°C - +320°C

When the green light comes on the appliance 

is ready to use. The orange light remains on 

whilst the heating elements are operating.   

As soon as the plate reaches the set tempe-

rature the heating elements switch off and the 

orange light goes out.  

When the temperature falls below the set level 

1.3  CONNECTING TO THE POWER SUPPLY 

-  Before connecting the appliance to the 

mains, make sure that the voltage and 

frequency indicated on the data plate 

correspond to those of the actual supply 

system.

-  The appliance is set up to function as indi-

cated in the data plate located at the rear 

or on the hand side that the appliance.

-  To connect the appliance, simply connect a 

standardised plug suitable for the absorbed 

load to the supply cable and plug it into a 

suitable socket that must be fitted with an efficient earthing system in compliance with the standards in force .

-  To connect the appliance directly to the mains, it will be necessary to install an omnipolar cut out suitable for 

the load with a minimum distance between contacts of 3mm.

-  The feed voltage, when the machine is operating, must not differ from the rated voltage by more than ± 10%.

-  The appliance must be included in an unipotential system whose efficiency is checked in compliance with the 

standards in force. 

Fig. 2

Before delivering the appliance to the user:

- check that it operates correctly,  

- instruct the user on how to use it.   

2. 

OPERATING INSTRUCTIONS

The appliance must be used only for the purpose for which it was designed. Any other use is improper. 

During operation, supervise the appliance.  

2.1  STARTING UP FOR THE FIRST TIME  

Before starting up the appliance for the first time remove all the packing and thoroughly clean the protective 

industrial grease from the appliance  using water and normal detergent.  

BIMETAL PLATE - INSTRUCTIONS FOR USE

When the plate is warm, dampen very slightly with vegetable oil and wait until the plate reaches the desired tem

-

perature. For best cooking results, the temperature should be about 240°C - 250°C. The food may be cooked 

on the entire surface of the plate.

Fig. 3