Installation and operation
135026
11 / 16
EN
5.2
Operation
1. Clean the appliance observing indications in section
'Cleaning'
.
CAUTION!
Due to hygienic reasons, crushed ice from first production following
cleaning should be discarded and not used for beverage preparation, as
there may be cleaning agent remains left inside the ice container.
2. Place the appliance on a stable surface.
3. Plug the appliance into a single grounded socket.
4. Prepare ice cubes.
5. Put ice cubes in the ice container.
CAUTION!
Cut wounds hazard!
The blade at the bottom of the ice container is very sharp.
Never put hands into the ice container.
6. Place a suitable container under the ice chute.
7. Close the lid correctly.
8. Press the ON/OFF switch to switch the appliance off.
During crushing process, the ON/OFF switch is lit in green.
Ice cubes are crushed and transported through the ice chute.
The process of ice cube crushing takes approx. 30 seconds.
ATTENTION!
After crushing of ice, the motor is still operating.
Only when the motor is completely stopped, may you open the lid.
9. If the appliance is not to be used any more, and to switch it off, press the
ON/OFF switch and disconnect the appliance from mains power supply.
Summary of Contents for 135026
Page 1: ...2000 135026 ...
