- 26 -
4. Put the lid (2) on the sieve (3) and fasten it by turning up the protective blockings (6)
so that they „click into place” in places on the lid which are meant for this. If the
protective blockings have been fastened properly, the safety switch next to the
motor unit will activate. If the blockings are released, this switch will stay inactive
and the engine of the device will not work.
5. Put the pulp container (11) under the lid (2).
6. Put the juice bowl (10) under the pour of the sieve socle (4).
Operating the device
•
Make sure that the device is properly assembled.
•
Clean vegetable and fruit, cut these into proper pieces that fit into filling spout.
•
Plug the device into appropriate single electric socket.
•
The lever switch allows a choice of a speed level:
•
the upper position of the switch „1“ is meant for a high speed,
•
the lower position of the switch „2“ is meant for a low speed,
•
the „
“ position is meant for switching off the device.
•
For better results of extracting juice from fruit and vegetables the choice of „2“
position is recommended.
•
After choosing the speed level, put suitable fruit or vegetables in the passing
opening and press it with the tappet (1).
•
To achieve a better result of extracting juice, press the products slowly with the tappet.
WARNING! Hazard of injury!
Never push the fruit or vegetable with fingers or kitchen utensils. Always use the
tappet provided!
CAUTION!
Never use the device when some food products are not inserted, although all the
parts of device may be installed.
•
Mind that the juice bowl (10) is always under the pour when the device is working.
•
The extracted juice from vegetable or fruit comes from the pour of the sieve socle (4)
and gathers in the juice bowl (10). Plump is gathered in the plump container (11).
Summary of Contents for 150139
Page 2: ......
