Installation Instructions
1583011
19 / 32
EN
Pressure Check
The appliance is approved and by factory default prepared to operate with the type
of gas stated on the rating plate (liquid gas).
Check if the gas type stated on the rating plate is concurrent with the available gas
type.
ATTENTION!
The appliance functions well only when the gas supply pressure is
between the values given in Table 1 Gas Pressure Table for different gas
categories.
If the gas pipework pressure in the installation location is not concurrent with the
provided values, notify the gas supplier and do not operate the appliance until the
cause is clarified and removed.
Use a u-pipe manometer to measure pressure (at least 0.1 mbar resolution).
You may connect the manometer to a pressure connection (A, Fig. 2) behind the
appliance's control panel.
Fig. 2
Proceed in the following way:
1. Remove all gas controllers.
2. Unscrew bottom fastening screws and remove the control panel from the
appliance.
3. Remove the screw and sealing washer from the pressure connection (A).
4. Connect the manometer.
5. Start the appliance as described in instructions in section 'Gas Hob' and
check if the provided pressure is in the allowable range.
6. Disconnect the manometer again.
Summary of Contents for 1583011
Page 1: ...Flex 7360 1583011 ...
