5
• safety fuse of the feeder and inner mains can stand the loading of the device (see label of the matrix)
• mains are equipped with effective grounding according to standards (
Č
SN) and conditions given by law
• socket or switch of the feed is well accessible from device
We refuse any responsibility in case of not respecting above mentioned rules. Before the
fi
rst use it is necessary
to remove all the protection foil and to clean the device - see chapter „cleaning and maintenance“.
Maintenance: We recommend to have the device checked once a year by the proffesional service. Only quali
fi
ed
or competent persons can do interventions in the product.
INSTRUCTION FOR USE
Attention!Before the
fi
rst use of the device you must remove protection foil from all surfaces and wash the
device with water with detergent. Than splash it with clean water. Use the device under supervision. Never use
the device without oil or if the level of the oil is lower then min. line - danger of
fi
re. If the oil is dirty or you use
the oil longer time it may cause boiling over.
Do not fry more then 1 kg of food together in one bath.
Fill the device with frying oil not higher than the line on the side. Switch on with main switch (B) turn the knob
(E) to required position between 90°C - 180°C. Pilot lamps (C) and (D) will light. Pilot lamp (C) lights when the
device is in electricity. Pilot lamp (D) lights when the thermo spirals are on. Pilot lamp (D) goes out when the
device reaches required temperature. Switch the device off by turning the knob (E) into position „0“ and switch
over the switch (B) into position „0“.
Comments and recommendation
You must always check the level of oil, never use the device without oil. Use the device only under supervision.
C
B
E
D
