Bartscher 203.500, Instructions For Installation And Use Manual

4

PLACEMENT

The device must be instalated in well ventilated room what is necessary for regulation of the function of the 

device (technician must go by valid standard (ČSN....). If the device is situated close to the wall or if it is in 

contact with the furniture walls, these walls must resist the temperatures ranging to 60°C. Instalation, setting, 

putting into operation must be done by qualifi ed person who is competent for this and according to the valid 

standards.

Wrap up the device and check whether it was not damaged during transport. Settle the device on horizontal 

surface (max imbalance 2°).Settle the device under the fumehood to eliminate water steam and bad smell.

The device can be instalated separately or in a set with devices of our production. Min. distance 10 cm 

from other subjects must be kept.It is also necessary to prevent our product from contact with combustible 

materials. In this case you must make corresponding changes to secure heat izolation of combustible parts. 

Safety measures from the standpoint of the fi re protection according to ČSN 061008čl. 21:

TECHNICAL INSTRUCTIONS FOR INSTALATION AND REGULATION

Important:

The manufacturer does not provide warranty for defects caused by improper use, failure to instructions 

contained in the attached instructions for use and mistreatment of the appliances.

Installation, adjustment and repair of appliances for kitchens, as well as their removal because of possible 

damage to the gas can be carried out only under a maintenance contract, this contract may be signed with an 

authorized dealer, and must be complied with regulations and technical standards and regulations regarding 

the installation, power supply, gas connection and health & safety system.

These  instructions  are  intended  for  the  qualifi ed  technician  who  must  perform  the  installation,  put  it  into 

operation and test the appliance.

Any activity as settings, placement, rebalancing etc, must be made only when is device disconnected from 

electricity. If it is necessary to have the device connected to the electricity you must keep the highest attention 

to avoid any injuries.