- 31 -
•
In order to avoid failures of the compressor when assembling or transporting the
refrigerator, it should not be tilted over an angle of 45° at any time. Always use
condenser and door with care as damages affect the optimal use.
•
Locate the device where air can freely circulate in the surrounding area. Keep a
distance of at least 5 cm from every side.
•
Place the device in such a manner that the ventilation ducts are neither blocked or
covered.
•
Do not set up the refrigerator at places with high humidity or high temperatures, as
these effects may damage the device.
•
Never punch holes into the refrigerator. Never install foreign matters/ substances on
the refrigerator.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
Adjusting the hinges
•
The refrigerator's door hinges can be placed at either the left or right side.
Refrigerator for bottles 700.271 (Fig. 6)
•
Remove the lower cover (10).
•
Loosen both screws (7) and remove the
lower handle (8) along with nuts and
bolts (6) along the hinge shaft and
spacer (5).
•
Remove the door (4).
•
Unscrew the hinge bolt from the upper
handle (2) along with the nut (1) and ring
(3) and slide the entire assembly to the
other side of the door.
•
Hang the door on the hinge bolt (2).
•
Slide the bolt into the door, then unscrew
the handle (11) then switch with the lower
handle (8), the set of spacers and rings.
•
The hinged handles (9) located under
the handles (8) and (11) remain where
they are.
•
Close the lower cover (10).
Fig. 6
Summary of Contents for 280 LN
Page 2: ... 2 ...
