Installation and operation
100533
17 / 22
EN
By pressing the Start/Stop key, the time is stored and the setting may be used
again.
Repeat the steps above to use the remaining time storing keys for storing the
required values.
The set time may be freely modified for each time storing key.
To activate the set time, press one of the time storing keys.
The digital display will show the set time setting and the time will be counted
down. When the set time elapses, an acoustic signal sounds, and 'End' is shown
in the digital display.
To interrupt the time countdown, press the timer ON/OFF switch.
To switch the timer on or off, press and hold the timer ON/OFF switch.
Appliance Start-Up
1. Connect the appliance to the power supply.
2. Switch the ON/OFF switch to
'I'
position.
The green power indicator light in the ON/OFF switch lights up.
Preparing Food on Griddle Plate
1. Oil the roasting surface slightly.
NOTE!
The entire roasting surface is divided into two heating zones, which may
be independently controlled with respective operating elements.
Always heat up roasting surface first, before you put the food products on.
2. Set the desired temperature for each heating zone with the relevant temperature
controller.
The orange heating up indicator light for the selected zone lights up.
To heat the roasting surface up before the first use, schedule the heating time for
approx. 20 minutes.
When the set temperature is reached for a given heating zone, the suitable heating
up indicator light goes off. When the temperature drops, the thermostat switches
back on and the heating up indicator light is lit again.
3. Place the food products prepared for grilling one by one on the roasting surface.
4. Observe grilled products during grilling process.
5. Rotate grilled products in the meantime.
Summary of Contents for 6640
Page 1: ...6640 100533...
