- 33 -
Automatic defrosting
The device is equipped with the automatic defrosting system, which is performed
every 6 hours and takes 25 minutes.
Manual defrosting
When it is required to perform defrosting in other time than preset, press the button
for 6 seconds in order to start defrosting.
The LED defrosting indicator
will come on and will blink until the defrosting process is
finished.
After defrosting the LED defrosting indicator
comes off and the next defrosting will start
after 6 hours.
Cooling of food products
•
Whet the temperature inside the device reaches the preset value, the LED cooling
indicator comes off and the device is prepared for placing the appropriate food
products inside.
•
Prepare the appropriate food products.
NOTE!
Warm food should be cooled to room temperature prior to placing in the
refrigerated show-case.
•
The food is placed in the show-case through the sliding glass doors on the
operational side, which should be opened and then the food articles may be placed
on the shelf or lower operational surface.
•
Do not overfill the refrigerated show-case in order to prevent interfering of air
circulation in the device. The food products in the refrigerated show-case must not
block the air inlet and outlet holes.
•
To minimize loss of cold, keep the sliding doors open for as short of a time as
possible.
•
After emoving of required food products close the sliding glass doors.
•
After use of the device first disconnect it from the socket (pulling the plug!), then
disconnect the power supply cable from the adapter.
