- 28 -
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device
only in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
5.2 Operation
Before operation
•
Due to hygienic reasons before the first use of the device fill it with approx. 5 litres
of water and boil it for approx. 5 minutes; set the temperature control knob to
„obtaining juice / cooking“. Read instructions in section „Heating of liquids or
food“.
•
Then rotate the knob counterclockwise to position „0“, disconnect the device from the
socket (pull the plug!) and wait until it cools down. Empty the pot and rinse it
thoroughly with clean water.
Heating of liquids or food
WARNING! Electric shock hazard!
Avoid splashes of liquid during operation as it may cause short-circuit in
adjustment electronic parts and lead to injuries due to electric shock.
•
It is very important to always heat drinkable liquids only in the pot. Do not fill
Party stockpot with any non-drinkable liquids, like acids, lyes, oils, nitrates, etc.
CAUTION!
Never turn on the device without liquid or food, as it may lead to damages of
enamel coating!
Summary of Contents for A150510
Page 2: ......
