- 30 -
Removing of liquids/food
WARNING! Burn hazard!
During removing the lid there is a risk of burns cause by released steam
and condensate. Remove the lid carefully to allow the condensate to drain
into the pot.
•
Party stockpot allows for taking liquids or soups and serving them as required.
Then close the lid to reduce heat losses.
•
After use set the temperature controller in position „0“ and disconnect the device
from the power supply (pull the plug!), wait for the device to cool down, and empty it
completely.
The device is equipped with overheating/dry operation protection. In case of
accidental start-up without liquid or with its insufficient amount the protection will
be activated and the device will be automatically turned off.
Rotate the temperature control knob to position „0“, disconnect the device from
the socket (pull the plug!), and wait at least 30 minutes for cooling down.
After cooling down the pot may be refilled with liquid and used again as usually.
6. Cleaning and descaling
WARNING!
Before cleaning disconnect the electric power supply (pull the plug!)
and wait for the device to cool down.
The device is not designed for flushing with direct water jet. Therefore
do not use the pressurized jet for cleaning the device!
Never immerse the bottom and supply cable in water or other liquids!
Protect the device from the water penetration.
Regular cleaning
o
The device should be regularly cleaned after use and as required.
o
Always use the soft cloth only, never use any abrasive cleaning agents which may
scratch the device.
o
Do not use any flammable cleaning agents (alcohol, etc.) as they increase fire and
explosion hazard during the next use.
Summary of Contents for A150510
Page 2: ......
