- 27 -
5. Installation and operation
5.1 Installation
Positioning
•
Unpack the device and remove all packing material.
•
Remove the protective foil form the device. If there are any glue residues on the
device, remove them using appropriate solvent.
•
Screw the supplied feet into the appropriate holes.
CAUTION!
Never remove the rating plate and any warning signs from the device.
•
Place the device on top of an even, stable, dry, and water-resistant surface which
supports the weight of the device and is not heat sensitive.
•
Never place the device in humid or wet environment.
•
Never place the device on the flammable surfaces.
•
Never place the device near flammable and combustible materials.
•
The surface on which the device is placed must be easily accessible and sufficiently
large. To enable easy operation of the device and ensure proper air circulation, leave
the space of at least 50 cm at the back and on the sides of the device and 50 cm
from the top of it.
•
Set up the appliance device in such manner that the plug is accessible, so that the
appliance can be quickly disconnected from the power network if necessary.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device (see
rating plate). Connect the device only in case of compliance!
Connect the device only to properly installed single socket
with protective terminal.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
