- 38 -
HOT SURFACE! Risk of burns!
The filter basket, the riser pipe, and the coffee grounds are
very hot after the brewing process. Use the protective
gloves to remove them!
The device is equipped with
overheating/dry operation protection
. In case of
accidental start-up without water or with its insufficient amount the protection will
be activated and the device will be automatically turned off.
CAUTION!
When the overheating protection is activated
and the device turns off, disconnect it from the
socket (pull the plug!) and leave for cooling
down.
Remove the base and press the RESET button
on the bottom of the device.
The coffee machine is ready for the operation
again.
Coffee serving
Place the cup or glass under the drain tap, press the tap slightly down and hold until
the cup is filled with required amount of coffee.
Release the drain tap, which closes automatically.
In order to obtain full flow press the tap lever fully down.
NOTE!
The drain tap is located a little higher, therefore the coffee grounds remain on
the water tank bottom and do not enter the served coffee.
When the device is placed in normal position and the coffee does not flow, remove
the plug and fill the device with fresh water after cooling down, when required.
Instructions and advices
Before brewing another coffee batch rinse the coffee machine thoroughly with clod
water to cool it down.
Any drops arising from removing the filter basket and the wet coffee grounds should
be collected with use of coffee machine lid.
