- 25 -
•
With the use of the temperature control it is possible to adjust the temperature
gradually from approx. 30
°
C - 100
°
C.
•
Set the temperature control at the desired temperature by turning it clockwise (the
green control light of heating will go on). When the desired temperature is reached,
the control light goes off.
NOTE!
The heat is created via a heating coil in the bottom part of the mulled wine pot/
preserving pot. The electric temperature control with the temperature sensor are
placed here as well. The adjustment of temperature is done via the thermostat
switch.
NOTE!
The heating time depends on the liquid and the amount. When the desired liquid
temperature is reached the temperature controller shuts off automatically. In case
the liquid temperature drops below the desired temperature the temperature
controller switches on to keep the liquid at the set temperature over a larger
period of time.
•
In order to drain the liquid pull the small tap forward and hold it till the cup or container
is
filled. When this process is finished, let go of the small tap and it will shut off automa-
tically. In order to drain the liquid in a continuous way, stop the tap by pressing it.
•
Conditional on the system a quantity of approx. 1 litres remains in the container.
This quantity can be slightly reduced by carefully tilting the container forward.
WARNING! Hot surface!
While operating the device the surface of the container will be heated up
according to the adjusted temperature! Do not touch hot surface!
•
If the device is not going to be used, turn the temperature control to the „0“ position,
disconnect it from the power socket (take out the plug!), leave the device to cool and
drain the liquid.
Preserving
•
The device can also be used for preserving foodstuffs in jars.
•
Use the enclosed grid for putting the jars in the container. The grate helps a better
circulation of the boiling water under and between the jars and at the same time a
quicker heating of them.
Summary of Contents for A200052
Page 2: ......
