11
ENGLISH
GB
Connect the switch-off to the terminal strip (
B
)
of the device, as shown in the drawing and
block diagram (see the attachments). Use
cable type H07RN-F or better, min. heat
resistance of 80 °C.
Firmly press the end of the cable (
C
).
Replace the terminal strip cover.
The device is equipped with the equipotential
clamp (M). The terminal is marked with
appropriate sticker:
.
8.4.
Installation of the appliance in a line
To fix the appliance in a line (neighboring) follow
the steps:
1. Dismantle the control panel, and remove the
cast iron frame from the chimney if necessary.
2. Apply the sealing tape (
A
) onto the joining
sides.
3. Place the appliances next to each other and in
a horizontal position (by adjusting the feet).
4. Connect the appliances with the joining
elements.
M
A
A
B
C
C
B
C
Summary of Contents for FTE91MA0
Page 15: ...ANLAGEN ATTACHMENTS ANNEXES ALLEGATI ANEXOS ANEXOS BIJLAGEN ZA CZNIKI...
Page 20: ...NOTE...
Page 21: ...NOTE...
