- 29 -
The LED defrost indicator
will come on and will flash until the end of the defrost
process. After defrost has finished, the LED defrost indicator
will go off and the next
defrost cycle will begin in 6 hours.
•
In case of planned break in the device operation turn it off with use of ON/OFF
switch and disconnect from the power supply (remove the plug from the socket!).
Tips for the user
•
To minimize loss of cold in the device, the door should be closed as quickly as
possible and not opened unless necessary.
•
Do not block the ventilation ducts. Air must circulate freely to ensure proper cooling.
•
Articles inside the device must be kept at appropriate distances from one another.
Cooling effectiveness is reduced when they are too close together.
•
Adjust the height of grids to the size of articles stored.
•
Allow warm dishes to reach room temperature before placing inside the device.
•
In the event of a power failure, do not open the door unless necessary to avoid loss
of cold air.
•
After a power failure or unplugging the device, do not connect it to a power source for
at least 5 minutes.
6. Cleaning and maintenance
6.1 Safety advice
o
Before beginning with repair or cleaning works make sure the device has been
disconnected from power supply and has cooled down.
o
Do not use any acid agents and make sure no water ingresses the device.
o
To protect yourself from electric shock, never immerse the device, its cables and
the plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets.
Therefore, you must not use any kind of pressure water jet for cleaning the device!
