Operating Instruction
117723
39 / 68
EN
There is a possibility of starting the program with the selected thermal processing
phase (different from the first set):
2. After having selected the program, press the 'Advanced customisation' key and
use the arrow to go to the desired thermal processing phase.
3. Press START key to start the thermal processing mode with this thermal
processing phase.
If pre-heating is included in this program, it will not be executed. The program can
be modified using the CookingTuner interface before pressing the 'Advanced
customisation' key.
Creating Thermal Processing Program
A thermal processing program is made up of several phases, which the appliance
performs in ascending order (thermal processing phase 1, phase 2, phase 3, etc.)
moving from one to another automatically.
1. After setting the parameters for the
initial phase (thermal processing
phase 1), press
'+'
key (11, Fig. 20)
to create a subsequent thermal
processing phase.
2. Set the required parameters for
thermal processing phase 2.
3. When creating subsequent thermal
processing phases, continue as
described above.
Fig. 20
You can also create and enter new thermal processing phases between previously
created phases. The new thermal processing phase will be placed under the one
selected when you press key 11.
4. At the end of programming, press START (Fig. 20) to start thermal processing.
5. To delete a thermal processing phase, press 'Remove phase' key (12, Fig. 20).
