- 22 -
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not drill any holes in the device nor attach any other objects to it.
•
Do not place any heavy objects on the device.
•
Never grasp the plug with wet or moist hands. Always ensure the power cord and
plug are dry before activating the device.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
Avoid contact between the device and water. Do not allow the water to be affected
by rain, dripping water or other forms of moisture. This may lead to damage to the
device or electric shock.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
5.2 Installation and connection
•
Unpack the device and remove all packing material.
•
Locate the device in a safe place that can support its weight.
•
Never put the device on a flammable surface.
•
Do not locate the device near an open flame, electric heater, oven or other heat
source, nor in direct sunlight. High temperatures can damage the device’s surface
and have a negative impact on cooling capacity while increasing energy use.
•
To avoid damage to the compressor, do not tilt the device to an angle greater than 45°
during setup or transport. Be careful when touching the condenser and doors, as
damage to them will negatively impact the working of the device.
•
Set the feet so that the device stands in a stable position.
