- 29 -
5.2 Operation
Before use, clean ithe device according to the instructions in section
6 “Cleaning”
.
First, connect the supplied power supply cable to the IEC connector at the rear side
of the device, then plug in the device to the single grounded socket.
Turn the device on using the ON/OFF switch located on the front of the device. The
device will heat-up automatically to the maximum temperature of approx. 100 °C.
Heating-up time is approx. 7 minutes.
During heating-up the red heating-up indicator light is on. When the temperature has
been reached, the red heating-up indicator light is off and the green ready for operation
indicator light is on. The device is now ready to maintain the food temperature.
When the temperature of the warming plate falls below 95 °C, the green ready for
operation indicator light is off, the termostat turns on and the device is heated-up
again. The red indicator light comes on again. Due to this function the warming tray is
protected against overheating.
HOT SURFACE! Risk of burns!
External surfaces of the device become very hot during its
operation. Do not touch the hot surfaces! Move the device
using only the side handles.
When the green ready for operation indicator light comes on, you can disconnect
the device from the power supply, detach the power supply cable and leave the
device in a required place. Even disconnected from the power supply, the warming
plate emits heat sill for approx. 37 minutes.
CAUTION!
The warming tray is not designed for keeping warm the food placed directly
on the surface. Use suitable plates to keep the food warm.
Before you place the food on the warming plate make sure that it is positioned on a
flat and stable surface to prevent sliding down or falling over of the food cookware.
