Take-Up Spring Replacement
After many adjustments, the take-up spring may begin to show wear. Adjusting the take-up
spring may not correct tension problems. In this case, the take-up spring will have to be
replaced.
Replacing the Take-Up Spring
1. Remove the outer tension knob, turning it
counterclockwise
until it comes off the
tension assembly.
2. Remove the tension spring washer from the tension assembly post.
3. Remove the inner tension knob, including the spring that rests inside it.
4. Remove the first thread disc (with white felt discs), then the green felt disc.
5. Remove the white plastic plate (flat). You may need to push on it from behind with the
blade of a flat screwdriver. Notice the position of the take-up spring in reference to the
assembly port. There is a groove in back where the spring locks in place.
6. Remove the worn take-up spring.
7. Insert the new spring, placing it in the same position as the old one. Make sure the new
spring rests against the brass post.
8. Replace the white plastic disc with the flat side facing you. Make sure it is
firmly
seated on top of the brass post
(it will partially cover the post) so the take-up spring
cannot go around the post. The white plastic disc traps the spring in place.
9. Replace the green felt disc.
10. Replace the thread disc with the white felt discs.
3
-
4
Troubleshooting
BE
V
T Series
Mechanical
Guide
11. Replace the inner tension knob with the spring and washer resting inside it.
12. Replace the outer tension knob, turning it
clockwise
until it is secure, but not too tight,
on the tension assembly.
13. Adjust the new take-up spring as described earlier in manual.
Summary of Contents for BEVT Series
