6. Check that ½ of the eye of the needle can be seen below the hook basket. See
illustration below.
Note: If necessary use a small flashlight to view the needle eye.
If the eye of the needle is out of adjustment, adjust the needle depth, see Needle Depth
Adjustment.
Checking Needle Depth and Hook Timing with (optional) Gauge
The following instructions require Optional
Needle Depth Gauge Part #HB220040.
Hook timing and needle depth can be checked at
the same time using the Needle Depth Gauge.
1. Make sure the sewing head is at Needle #1.
2. Power down the machine.
3. Remove the throat plate, if checking hook
timing.
4. Remove the bobbin case.
5. Remove the back center cover to gain access to the main pulley degree wheel.
3
-
8
Troubleshooting
BE
V
T Series
Mechanical
Guide
Summary of Contents for BEVT Series
