Base aire AirWerx 90, Installation & Operation Manual

Identification

For

 future reference, write down the model, serial number, and date of purchase for your dehumidifier. 

This

 is extremely helpful if you need to seek assistance in the future. The data label on the side of 

your

 unit has the key characteristics of your specific unit.

Serial

Number

: ______________                    

Date

of

Purchase

: _____________

For

 additional questions concerning your dehumidifier, the following options are available:

Model

number

: 

AirWerx

90

·

 Contact your installing contractor 

·

 E

-

mail

: 

sales@baseaire

.

com

Electrical Supply

3

Power Supply: 115 V, 60 Hz AC, Single Phase

Outlet Requirement:  3-Prong, GFI

Circuit Protector: 15 Amp

To reduce the risk of injury:
          1. Disconnect electrical power before servicing.

WARNING

: 240 Volts AC may cause serious injury from electric shock.

          2. Only plug unit into grounded electrical circuit.
          3. Do not use an extension cord.
          4. Do not use a plug adapter.

Principle of  Operation

The AirWerx Series Dehumidifier utilizes its integral humidistat to monitor the conditioned space. When 
the relative humidity goes above the selected set point, the dehumidifier will energize. Air is drawn 
across an evaporator coil, which is cooler than the dew point of air. This means moisture will condense 
out of the air. The air is then reheated through the condenser coil and distributed back into the room.

Installation

WARNING

: Do not install your dehumidifier in a corrosive environment. Some liquid vapor barriers 

dry via "solvent evaporation". Always make sure that barrier is completely dry and area is throughly 
ventilated before installing dehumidifier.

The area to be controlled should be sealed with a vapor barrier. If the unit is installed in a crawlspace, 
all vents should be sealed.