6
Transportation And Storage
Pay attention to information about transportation and storage.
If you store or transport the device incorrectly, the device may be damaged.
Transportation
Before
transporting the equipment, please observe the following regulations:
Turn off the device
Hold the power plug while unplugging the power cord from the power outlet.
If the device was in use before, please wait until the timing period is over before transferring the
device.
Do not drag the device with the power cord during transportation to prevent the device from moving
and vibrating to avoid damage to the electrode.
After
transporting the equipment, please observe the following regulations:
Install the equipment in an upright position after transportation.
Storage
When the device is not in use, please observe the following storage conditions:
Store the Baseaire UVC2 Pro ozone generator in a dry place to avoid the influence of bad weather,
and cover it to protect it from invasive dust.
When the equipment is not in use, always disconnect the power supply.
Clean Electrode
Use a dry (lint-free) or damp cloth to clean the components. After cleaning, make sure that no fibers
(fluff) remain on the electrode.
The electrode can be cleaned in the built-in state. Before cleaning the electrode, check for cracks. Do
not use damaged parts!
If possible, place the device in the center of the room to ensure optimal air circulation.
Do not install this machine near flammable substances or gases.
Make sure to place the device on a dry and vibration-free surface.
The following requirements must be met when installing the Baseaire UVC2 Pro ozone generator:
Do not use the device before the electrodes are completely dry.
Make sure that there are no obstructions at the air inlet and outlet.
Ensure that the equipment is protected from splash water.
Only use the Baseaire UVC2 Pro ozone generator according to the parameters provided in the
"Technical Data" chapter.
Summary of Contents for UVC2 Pro
Page 10: ...8 Electrical wiring diagram...
