nOrMaL WEIGHInG ScaLE OPEratIOn
To use as General Weighing Scale (not referring to Fat / Hydration %).
1. Turn unit on by lightly tapping on the lower right corner of the scale
platform. LCD will “wake up” to General Weighing Mode, showing
“0.0 kg” or “0.0 lb”.
2. Step on the scale gently (
do not jump on the scale
). LCD will im-
mediately display incrementing digits until it stabilizes, followed by
flashes and then locked digits, showing your weight value. After a
few seconds, LCD will automatically shut down.
ErrOr & OtHEr LcD MESSaGE
LCD may occasionally show an error message ‘Err’. Simply turn off the
unit for a brief moment, or remove and re-install battery as a total re-set.
Then turn on again to resume operation.
1.
all segments lit up simultaneously:
Indicates all segments per-
forming correctly.
2.
“-----”:
Strain gauge sensor zero point setting too low below lower
range. Cannot operate properly.
3.
“Err”:
Overload, or strain gauge sensor zero point too high beyond
upper range.
4.
“LO”:
Battery power running low.
5.
“Err-h”:
The computed Fat % rate too high above range of upper
limit.
6.
“Err-l”:
The computed Fat % rate too low below range of lower limit.
cLEanInG, MaIntEnancE & PrOPEr uSaGE
1. Use a damp, soft cloth with mild detergent to clean the device. DO
NOT use a strong chemical solution such as alcohol or benzene for
cleaning.
2. Make certain the weighing platform surface is dry before using be-
cause the weighing platform is slippery when wet.
3. Always use scale on a hard flat surface. Do not use on carpets,
mats. Remove the batteries if the scale is not going to be used for
a long period of time.
4. Do not drop the device, or jump on the device when using. Avoid
strong impact and sudden shaking as it is a precision measuring de-
vice. The construction is delicate and sensitive to all unwanted ex-
ternal impact.
5. Do not insert any objects into any openings on the unit.
6. Do not open the unit.
6
