31
11. Troubleshooting
Problem
Remedy
No display indication
•
Is the soldering station connected to the mains voltage and is it switched
on?
•
Has the fuse for the soldering station tripped?
Warning sound is audible and
"ERROR" flashes in the display
•
Is the soldering gun connected properly to the soldering station?
•
The soldering gun may be defective (cable, heating element or tempera-
ture sensor).
The set temperature is briefly ex
-
ceeded when heating
•
This is due to the functional principle and normal.
If you set, e.g., a temperature of +300 °C (lower display line "SET"), the
temperature displayed in the upper line ("TEMP.") that is measured via the
temperature sensor in the heating element will briefly reach, e.g., +310 °C.
The solder does not liquefy.
•
The temperature is set too low.
•
The heat of the soldering gun is discharged too quickly (e.g. when working
on larger pieces). Set a higher temperature or use a soldering tip with a
larger/flatter tip.
•
The soldering gun is not suitable for soldering work (e.g. soldering gutters).
•
The soldering station is only suitable for working with soft solders.
The set temperature is incorrect
•
If you check the temperature of the soldering tip with a high-quality meter,
there will be slight deviations for constructional reasons (the temperature
sensor will measure the temperature in the heating element, the meter will
measure the temperature on the outside of the soldering tip).
Smoke development at the solder-
ing tip
• The flux agent in the core solder will evaporate while soldering. This is
normal. Ensure sufficient ventilation at the workplace, do not inhale the
flux agent vapours.
12. Disposal
Electronic devices are recyclable and should not be disposed of in household waste. Dispose of the
product according to the applicable statutory provisions at the end of its service life.
