Enter the following key combination to enter a new Master Code:
0
New Master Code
#
Example:
0
4321
#
10.5 Assigning ID Cards and User Codes to OUTPUT 1
10.5.1 What is a User Number
If you wish to programme an ID card or a user code to activate the relay output “OUTPUT 1” (E),
you must always assign a user number to that card or code.
A user number is a number under which the ID card and/or the user code is saved.
In order to make clear the connection between the user number, ID card and user code, the
following example table provides a list of 7 programmed user numbers.
User number
ID card
Usercode
1111
ID card 1
1112
ID card 2
1113
9876
1114
4289
1115
ID card 3
1116
8946
A user number is thus nothing other than a memory location under which you must save ID card
and/or the user code.
Note that the user numbers for “OUTPUT 1” (E) must be 4 digits long and those
for “OUTPUT 2” (F) must be 3 digits. The user code must always be 4-8 digits
long.
User numbers cannot be assigned twice.
42
Summary of Contents for 1833947
