• Gently push the memory card into the slot until it clicks into place. Ensure that the memory
card engages in the slot. This is the only way of ensuring reliable storage.
•
To remove the memory card, briefly press on the card until it is unlocked and pushed up
slightly. You can then easily remove the card.
• Carefully close the rubber cover to ensure protection against moisture and dust.
If the memory card is not recognised when triggering memory with the trigger
button (6) for image storage, check the memory capacity, the correct fit or the
correct data formatting of the memory card.
10. Setup
a) Turning the camera on and off
• Use the Power button (3) to turn the camera on and off.
• To turn the camera on, press and hold down the Power button for approx. two to three
seconds.
• The camera will turn on and display the start screen for approx. four seconds.
• The currently captured thermal image is displayed.
• To turn the camera off, press and hold down the Power button for approx. two seconds. The
device turns off.
b) Control keypad
Different buttons are used to control and set the measuring instrument. The buttons have the
following functions:
Power button (3)
To turn the device on or off, press and hold down the button for approx. two seconds.
Automatic power-off can be set in the menu. The device will then automatically power off after
a preset time.
OK button (7)
The OK button opens the settings menu. In the settings menu, this button is used as a selection
button (Enter) when pressed briefly.
Use the Return button to exit the settings menu.
25
