Final Checks
Before you run your car, check the following.
1.
C
heck that all the screws are fully tightened unless otherwise mentioned in
the build stages. If the screws are threaded into metal parts make sure you
applied thread lock to stop them coming loose.
2.
C
heck there are no binding parts, the suspension parts should drop under
their own weight (with no shock absorbers mounted). The car should also
roll freely with very little effort.
3. The batteries should be fresh in both the Transmitter and Receiver.
4. The servos and servo linkages should be correctly installed and ad
j
usted.
5. The area you wish to operate the car should be safe.
6. Make sure that no one is using the same frequency as you if you are not
using 2.4gh
z
.
Summary of Contents for BZ-222 PRO
