Bask Mistmaster
®
3-in-1 Compact Misting System: Mist Station Kit Instructions
v.210119
Page
11
of
20
Pull back on the Quick Disconnect’s (D) sleeve
while pushing onto the auxiliary output.
Pull back on the Quick disconnect’s (D)
body to disengage.
Insert tubing by holding the body of the Quick
Disconnect (D) and pushing the tubing into the
push to connect end.
Auxiliary Output / Quick Disconnect
8.
Using the end of the 50 feet of Tubing nearest to your Mistmaster (after completing step 6 above), insert the end
of the Tubing into the Quick Disconnect (D). Push the Tubing firmly into the Quick Disconnect (D) and then pull
gently on the tubing to ensure it is secured.
Push to Connect / Disconnect
9.
Ensuring that the Tubing between your Mistmaster and the first Riser lies flat on the ground without looping or
bending; avoid rough or sharp surfaces (e.g., rocks) that can create abrasion and damage the tubing. Cut the Tubing
to the proper length using the Tube Cutter provided, ensuring that the cut is straight and does not cause the Tubing
to crimp, bend or be distorted.
10.
Align the Tee at the bottom of the first Riser so that one connector points toward your Mistmaster; then insert the
end of the Tubing extending from your Mistmaster into the Tee connector. Push in firmly and then pull gently to
ensure it is secure.
11.
Insert the open end of the remaining Tubing (what remains of th 50-feet piece) into the other side of the Tee at the
bottom of first Riser. Push in firmly and then pull gently to ensure it is secure.
12.
Follow the same process (steps 10-12) to connect Tubing between the remaining Risers (and/or Overhead Mist
Nozzles if applicable; see INSTALLING YOUR MIST STATION OVERHEAD KIT later in these instructions).
Release the tubing by pulling the ring of the push
to connect on the Quick Disconnect (D) and pulling
the tubing away.
