Bask Mistmaster
®
3-in-1 Compact Misting System: Mist Station Kit Instructions
v.210119
Page
8
of
20
Installing your Mist Station Riser Kit
Bask Risers are designed for ground installation approximately 8 to 10 feet (~2.4 to 3.1 meters) apart along the
perimeter of your desired coverage area, such as along hedges* or tree lines, or on landscape islands. Each Riser
elevates a Mist Nozzle to approximately 24 inches (~61 cm) above the ground, allowing your Mistmaster to propel mist
upward to treat the surrounding area.
*45° angle adapters also available.
Unless otherwise specified, instructions apply to installation of either Slim Risers or Ultra-Slim Risers.
Position Your Mistmaster and Risers
1.
Evaluate the area you intend to treat and determine the best location for your Mistmaster device depending on
your expected use, insect control, sanitization, odor control or plant health.
•
Position your Mistmaster where it can remain connected to its Battery Charger (18) and plugged into an AC
power source during stationary use and both kept in a dry, controlled environment. Always disconnect
charger prior to transportable use. Use only the charger and charger extender offered by Bask.
•
Bask recommends positioning your Mistmaster in an area that is easily accessible, ensuring that it does not
block walkways or create a tripping hazard.
2.
Determine the best location for each Riser. For best results, position Risers approximately 8 to 10 feet (~2.4 to 3.1
meters) apart along the outside perimeter of your desired coverage area.
•
Use care to ensure mist does not drift to neighboring properties and does not adversely impact furniture,
landscaping, pools or fountains, and other structures.
•
Bask recommends positioning Risers along hedges*, tree lines, or on landscape islands where there are no
existing structures on which to mount Overhead Mist Nozzles.
*45° angle adapters also available.
•
Do not position Risers or lay Tubing in areas where they may be damaged by lawn mowers or motor
vehicles, or where they create a tripping hazard.
3.
Using the Stakes provided in your kit, mount each Base (for Slim Risers) or Tee Base (for Ultra-Slim Risers) to the
ground surface using a hammer or mallet to gently drive the Stake through the Base or Tee Base and into the
ground as illustrated below. Ensure each Base or Tee Base maintains a vertical position. Never hammer on the
riser!
