BE1-51/27C General Information
1-8
Power Supply
Input power may be obtained from a variety of ac or dc external power
sources. Refer to Table 1-1 for available power supply options
Table 1-1. Power Supply Specifications
Type
Nominal
Input
Voltage
Input
Voltage
Range
Burden
at
Nominal
O
48 Vdc
24 to 60 Vdc
6.6 W
P
125 Vdc
120 Vdc
62 to 150 Vdc
90 to 132 Vdc
6.7 W
12.8 W
R
24 Vdc
12 to 32 Vdc
7.2 W
S *
48 Vdc
125 Vdc
24 to 60 Vdc
62 to 150 Vdc
5.0 W
5.3 W
T
250 Vdc
230 Vac
140 to 280 Vdc
190 to 270 Vac
7.8 W
19.8 VA
NOTES:
All references are at 50/60 Hz.
*
Type S Power Supply is field selectable for 48 or 125 Vdc. Selection
must be implemented at time of installation. This Power Supply option
is factory set for 125 Vdc.
Isolation
1500 Vac at 60 hertz for one minute in accordance with IEC 255-5 and
ANSI/IEEE C37.90-1989 (Dielectric Test).
Radio Frequency
Field Tested using a five watt, hand-held transceiver operating at
Interference (RFI)
random frequencies centered around 144 MHz and 440 MHz, with the
antenna located six inches from the relay in both horizontal and vertical
planes.
Surge Withstand Capability
Qualified to ANSI/IEEE C37.90.1-1989
Standard Surge Withstand Capabil-
ity (SWC) Tests for Protective Relays and Relay Systems.
UL Recognized
UL Recognized per Standard 508, UL File No. E97033. Note: Relay is not
UL Recognized for output contact voltages greater than 250 volts and input
power supply voltages greater than 150 volts.
Operating Temperature
-40
"
C (-40
"
F) to +70
"
C (+158
"
F).
Storage Temperature
-65
"
C (-85
"
F) to +100
"
C (+212
"
F).
Shock
In standard tests, the relay has withstood 15 g in each of three mutually
perpendicular planes without structural damage or degradation of perfor-
mance.
Summary of Contents for BE-51/27C
