Basler BE1-40Q, Instruction Manual

BE1-40Q Maintenance

6-1

CAUTION

Substitution of printed circuit boards or individual components does not necessarily mean
the relay will operate properly.  Always test the relay before placing it in operation.

SECTION 6 • MAINTENANCE

GENERAL

BE1-40Q Loss of Excitation Relays require no preventive maintenance other than a periodic operational test
(refer to Section 5 for operational test procedure).  If the relay fails to function properly, and factory repair
is desired, contact the Customer Service Department of the Power Systems Group, Basler Electric, for a
return authorization number prior to shipping.

IN-HOUSE REPAIR

In-house  replacement  of  individual  components  may  be  difficult  and  should  not  be  attempted  unless
appropriate equipment and qualified personnel are available.

When complete boards or assemblies are needed, the following information is required.

1.

Relay model and style number

2.

Relay serial number

3.

Board or assembly

a) Part number
b) Serial number
c) Revision letter

4.

The name of the board or assembly.

STORAGE

This protective relay contains aluminum electrolytic capacitors which generally have a life expectancy in
excess of 10 years at storage temperatures less than 40

!

 C.  Typically, the life expectancy of the capacitor

is cut in half for every 10

!

C rise in temperature.  Storage life can be extended if, at one-year intervals, power

is applied to the relay for a period of thirty minutes.

TEST PLUG

Test plugs (Basler part number 10095 or G.E. part number XLA12A1) provide a quick, easy method of
testing relays without removing them from their case.  Test plugs are simply substituted for the connection
plugs. This provides access to the external stud connections as well as to the internal circuitry.

Test plugs consist of black and red phenolic moldings with twenty electrically separated contact fingers
connected to ten coaxial binding posts.  Fingers on the black side are connected to the inner binding posts
(black thumb nuts) and tap into the relay internal circuitry.  Fingers on the red side of the test plug are
connected to the outer binding posts (red thumb nuts) and also connect to the relay case terminals.

When  testing  circuits  connected  to  the  bottom  set  of  case  terminals,  the  test  plug  is  inserted  with  the
numbers 1 through 10 facing up.  Similarly, when using the test plug in the upper part of the relay, the
numbers 11 through 20 are faceup.  It is impossible, due to the construction of the test plug, to insert it with
the wrong orientation.