Operation and Features
3-16
Basler L301kc
DRAFT
3.5.4 System Design Calculations
Assuming that the camera operating requirements listed in Section
and the system design
requirements met in Section
are met the formulas below can be used to calculate the basic
design criteria for your system.
Magnification
where:
β
= magnification
n = number of line captures needed to move the image from sensor line
to sensor line (see Table 3-1)
∆
y = distance the conveyor moves per line capture
Line of View
where: L = length of the line of view of each sensor line
Aspect Ratio
The aspect ratio of your captured images is determined by the value of “n” in the magnification
equation. The value can be set from 1 to 16. If the value is set to 8, the aspect ratio of the captured
images will be 1 to 1. The aspect ratios for various values of “n” are listed in Table 3-1. The aspect
ratios in the table are width to height where width is in the direction of conveyor travel and height
is along the axis of the sensor lines.
Once the magnification has been determined, you can select a lens with the appropriate focal
length and determine the correct distance between the camera and the conveyor.
n
Ratio
n
Ratio
n
Ratio
n
Ratio
1
1/8
5
5/8
9
9/8
13
13/8
2
1/4
6
3/4
10
5/4
14
7/4
3
3/8
7
7/8
11
11/8
15
15/8
4
1/2
8
1/1
12
3/2
16
2/1
Table 3-1: Aspect Ratios for Values of n
β
112 µm
n
∆
×
y
------------------
=
L
29.372 mm
1
β
---
×
=
Summary of Contents for L301kc
