Configuring the Camera
Basler L301kc
4-15
DRAFT
4.2.4.5 Spatial Correction Delay in Lines
Purpose:
To set the delay in lines for spatial correction or to read the delay in lines. See Section
for an explanation of spatial correction.
Type:
This is a read or write command.
Read Command:
Cmd-ID
R/W-Flag
Data Length
Data
0xAD
1
1
-
Response:
Cmd-ID
R/W-Flag
Data Length
Data
0xAD
0
1
1 Byte
Write Command:
Cmd-ID
R/W-Flag
Data Length
Data
0xAD
0
1
1 Byte
Response:
None
Data Format:
Byte 1
An ID that specifies the spatial correction delay in lines
(see the table below).
ID
Spatial Correction Delay in Lines
0x00
No spatial correction
0x01
One line
0x02
Two lines
0x03
Three lines
0x04
Four lines
0x05
Five lines
0x06
Six lines
0x07
Seven lines
0x08
Eight lines
0x09
Nine lines
0x0A
Ten lines
0x0B
Eleven lines
0x0C
Twelve lines
0x0D
Thirteen lines
0x0E
Fourteen lines
0x0F
Fiveteen lines
0x10
Sixteen lines
Summary of Contents for L301kc
