Configuring the Camera
4-12
Basler L301kc
DRAFT
4.2.4.2 Exposure Time Control Mode
Purpose:
To set the exposure time control mode or to read the current exposure time control mode
setting. See Section
for an explanation of exposure time control modes.
Type:
This is a read or write command.
Read Command:
Cmd-ID
R/W-Flag
Data Length
Data
0xA0
1
1
-
Response:
Cmd-ID
R/W-Flag
Data Length
Data
0xA0
0
1
1 Byte
Write Command:
Cmd-ID
R/W-Flag
Data Length
Data
0xA0
0
1
1 Byte
Response:
None
Data Format:
Byte 1
An ID that specifies the exposure mode
(see the table below).
ID
Exposure Time Control Mode
0x00
Free-run, Programmable
0x02
Free-run, Edge-controlled
0x04
ExSync, Level-controlled
0x05
ExSync, Programmable
0x06
ExSync, Edge-controlled
Summary of Contents for L301kc
