Bastl Instruments KNIT RIDER EXPANDER v1.0 Assembly Manual Download

Page: 2 / 4

Before starting this kit, prepare the following tools:

● Soldering iron (1520W)
● Multimeter
● Flush cutters
● Wrench No. 8
● Protective eyewear

We suggest that you work in a clean and a well lit and ventilated environment to avoid accidents or

losing any of the small components.

Also briefly go through this guide and make sure that you understand all the steps.

BOTTOM BOARD

Before you start soldering, take your time and find the resistors values

Now insert and solder all eight

resistors

(4x 1k, 4x 100k). Then snip the leads as close to the PCB as

you can (be sure to make this step on all remaining leads in the course of this guide).

Summary of Contents for KNIT RIDER EXPANDER v1.0

Page 1: ...o identify electronic components before starting this kit However if you have never soldered before check out this tutorial first We even included some of the best quality 1 solder to help you solder...

Page 2: ...ents Also briefly go through this guide and make sure that you understand all the steps BOTTOM BOARD Before you start soldering take your time and find the resistors values using a multimeter 2 Now in...

Page 3: ...and solder the 6 pin male header Be careful to solder the pinheader straight You may first solder the middle pin then take the board in your hand and re heat that pin while pressing down on the header...

Page 4: ...xpander to the Knit Rider module with the provided cable see the manual and you are ready to enjoy your new module Before you connect anything make sure that your system is disconnected from power Als...