Place the
front panel
on. Make sure that the components are properly aligned. Screw the panel with
washers
and
nuts
(don't tighten them too much as you may damage the panel). Push the LEDs leads
to fit its head on the panel. Make sure that everything is properly aligned. Finally you can solder all the
components.
Congratulations! You have made it through, now just connect the expander to the Knit Rider module with
the provided cable (see the
) and you are ready to enjoy your new module.
Before you connect anything, make sure that your system is disconnected from power. Also make sure
that cable connections on both modules are in the same side!
TROUBLESHOOTING
First check out the
If you are still in trouble you can send the detailed description of the problem with enclosed
highresolution photos on
diy@bastlinstruments.com
.
If you think that you are unable to make the module work on your own, consider our “
service.
4
