6
ASSEMBLY INSTRUCTIONS
(Continued)
5. Insert anti-tip wheel into holding bar on motor housing and
secure with pin.
X8R Only
6. Unpack remote control and install batteries with plus and minus
poles as indicated in the diagram in the receiver compartment of
the unit.
4. Place the battery pack on the battery
tray. Insert the 3-prong battery plug
into the caddy outlet so the notch
aligns properly and attach T-connector onto the battery.
Then attach Velcro strap. Tightly fasten the Velcro strap
underneath the battery tray and around the battery. It is
recommended that you
DO NOT
fasten the screw on the plug
to the outlet, so in case of tip-over, the cable can unplug from
the socket.
Note: BEFORE CONNECTING make sure that caddy power is OFF, Rheostat Speed
Control is in OFF position and the remote control is stored securely!
