23
English
.
sheets can bend under their own
weight
The sheets must be supported on
both sides, at the edges and close to the
saw cut.
e Do not use blunt or damaged saw
blades
If saw blades with blunt or mis-
aligned teeth are used, the saw cut is too
narrow resulting in increased friction,
jamming of the blade and kickback.
f Before sawing, firmly tighten the
adjustments of the cutting depth
If the
settings adjust themselves during sawing,
the saw blade may become clamped and
a kickback will occur.
g Be especially careful, if you are making
a plunge cut in an existing wall or other
nonvisible area
The immersed saw
blade can jam when sawing into hidden
objects and cause a kickback.
SAFETY INSTRUCTIONS FOR THIS
PRECISION PLUNGE SAW
a Check before each use that the safety
guard closes correctly Do not use the
saw if the lower safety guard does not
move freely and does not close imme-
diately Never clamp or secure the
lower safety guard in the open position
If the saw should accidentally fall to the
ground, the lower safety guard may
become bent
Open the safety guard with
the retraction lever and ensure that it
moves freely. Check that it does not inter-
fere with the saw blade or other compo-
nents, at any cutting angle or cutting
depth.
b Check the condition and operation of
the spring for the lower safety guard
Do not use the equipment if the lower
safety guard and spring do not work
perfectly
Damaged parts, adhesive
deposits or accumulations of shavings
retard the operation of the lower safety
guard.
c When making a plunge cut which is not
at right angles, make sure that the
saw’s guide plate can not move later-
ally
Lateral movements can cause the
saw blade to jam and hence result in
kickback.
d Do not put down the saw on the work-
bench or floor, without the lower safety
guard covering the saw blade
When
slowing down after use, an unprotected
saw blade will move the saw in the direc-
tion opposite to the cutting direction and
will saw whatever lies in its path. Pay
attention, therefore, to the deceleration
time of the saw.
e Use only sawblades with the correct
diameter according to what is printed
on the saw
f When sawing plastics please ensure
not to overheat the saw teeth tips to
avoid melting the plastic
SAFETY AND OPERATING
INSTRUCTIONS FOR DIAMOND
GRINDING WHEELS
Use
Only use the cut off grinding disc for cut off
grinding and not for rough grinding! Only use
the cut off grinding discs for the materials
indicated and not for any other materials. Risk
of injury! Cutting and cooling!
General Information
This tool insert is fragile, therefore extreme
care is required when handling it. The use of
damaged and incorrectly tensioned or installed
tool inserts is dangerous and can result in
serious injury.
Handling and storage
Tool inserts must be carefully handled and
transported. Tool inserts should be stored in
such a way that they are not exposed to any
mechanical damage or damaging environmen-
tal influences.
To avoid damage, remove the tool insert before
transporting an electric power tool.
Selection and safe and proper use
Pay attention to the data on the label or on the
tool insert, such as the restrictions on use,
safety instructions or other advice. Do not alter
the characteristic direction of motion of the tool
insert. If there is ambiguity over the selection of
tool inserts, contact the manufacturer or a
specialist. Adhere to the permissible rotation
speeds for the tool insert and the electric
power tool.
7062413-digital-display-MA-#-1604-19.indb 23
11-05-16 11:37
