English
8
played on the torque ring, the higher the
torque produced by the tool.
For drilling the machine will select the cor-
rect torque setting automatically.
7.4
Speed setting – only for drilling /
chuck
The machine has 2 drill speeds, which can
be adjusted by sliding the gear switch
(4)
forward or backwards. The number on the
gear switch
(4)
shows which position is
chosen.
Position 1:
For slow drilling, large drilling
diameter. The machine has higher torque at
a low speed.
Position 2:
For fast drilling or small drilling
diameter. The machine has lower torque at
a high speed.
For screwing the machine will select the
correct speed automatically.
7.5
Selection:
Select
Torque selector
Speed
Screwing
Bit holder
1 – 12*
Automatically
Drilling
Chuck
Automatically
1 or 2
*
• Select a low setting for small screws or
soft work material.
• Select a high setting for large screws,
hard work materials and when remov-
ing screws.
• You should preferably choose a setting
as low as possible when driving screws.
Select a higher setting if the motor slips
before the screw is fully tightened.
WARNING:
If the power tool gets exces-
sively hot in use, stop using the tool immedi-
ately and allow to cool before continuing
work. The cooling period can be reduced by
operating the drill at maximum speed with
no load. Always make sure the Motor Vents
(5)
are not blocked and do not allow dust to
enter the body of the tool through the Motor
Vents; dust, especially metallic dust, may
damage or destroy the tool.
7.6
Switching the machine on and off
The on/off switch
(8)
is used for activating
the machine and adjusting rotation speed.
• Pressing the on/off switch
(8)
will acti-
vate the machine, the further the switch
is being pushed, the faster the drill will
turn.
• Releasing the on/off switch
(8)
will stop
the machine.
7.7
LED lamp
The LED lamp
(14)
will be lit automatically as
soon as you press the ON/OFF switch
(8)
.
8. Accessories
Use only accessories with an allowable
speed matching at least the highest no-load
speed of the tool.
9. Maintenance and Cleaning
WARNING:
Always disconnect from the
mains power supply, before carrying out any
maintenance/ cleaning of the charger.
Remove the battery before carrying out any
maintenance/cleaning of the tool.
9.1
Maintenance
There are no inner parts of the tool which
need maintenance.
9.2
Cleaning
• Keep safety devices, ventilation open-
ings and the motor housing as free as
possible from dirt and dust. Rub the
electric power tool with a clean cloth or
blow over it with low pressure com-
pressed air.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap.
Do not use any cleaning or solvent materi-
als; these can attack the device’s plastic
components. Make sure that no water can
get inside the electric power tool.
7063778-Cordless_Twin_Drill-Ma-2107-13.indb 8
7063778-Cordless_Twin_Drill-Ma-2107-13.indb 8
13-09-2021 09:29
13-09-2021 09:29
