7
English
immediately and review your method of
use.
• Battery chargers are for indoors use
only. Ensure that the power supply and
charger are protected against moisture
at all times.
• Ensure that the lighting is adequate.
•
Ensure that the drill bit is securely fixed
in the chuck. Insecure drill bits can be
ejected from the machine causing a
hazard.
• Ensure that the drill bit is not in contact
with the workpiece prior to starting up
the tool.
•
Before drilling, check that there is suffi
-
cient clearance for the drill bit under the
workpiece.
• Drill bits get hot during operation, allow
to cool prior to handling them.
• NEVER use your hands to remove saw-
dust, chips or waste close by the bit.
• Examine the chuck regularly for signs of
wear or damage. Have damaged parts
repaired by a qualified service centre.
• ALWAYS wait until the drill has come to
a complete stop before putting it down.
3. Before use
• Avoid damage that can be caused by
screws, nails and other elements in your
workpiece; remove them before you
start working.
•
Use suitable detectors to find hidden
utility lines or call the local utility com-
pany for assistance (contact with elec-
tric lines can lead to fire or electrical
shock; damaging a gas line can result in
an explosion; penetrating a water pipe
will cause property damage or an elec-
trical shock).
• Secure the workpiece (a workpiece
clamped with clamping devices or in a
vice is held more securely than by
hand).
4. During use
• Hold power tool by insulated gripping
surfaces
(9)
, when performing an oper-
ation where the cutting accessory or
fastener may contact hidden wiring
(cutting accessory and fasteners con-
tacting a “live” wire may make exposed
metal parts of the power tool “live” and
could give the operator an electric
shock).
• In case of electrical or mechanical mal-
function, immediately switch off the
tool or unplug charger from power
source.
5.
Before first use
Remove the machine and the accessories
from the packaging. Check the machine for
transport damage and do not use the
machine in case of damages. Keep the
packing materials away from children, risk
of suffocation!
6. Intended use
The cordless drill/screwdriver is designed
for tightening and undoing screws, for drill-
ing in wood, metal and plastic, in each case
when using the appropriate bits/drills. The
equipment is to be used only for its pre-
scribed purpose.
7. Operation
7.1
Direction control
• The direction of rotation can be set
using the Forward/Reverse Switch
(7)
.
• For anti-clockwise rotation, push the
switch to the right.
• For clockwise rotation, push the switch
to the left.
Note:
When the Forward/Reverse Switch is
in the central position, the drill is locked and
cannot be switched on. Use this setting as a
safety feature to prevent the drill from being
switched on accidentally.
7.2
Select chuck / bit holder
(See
Fig. B
).
• Pull switch
(6)
down and turn the chuck /
bit holder.
• Release switch
(6)
and make sure the
selected chuck or bit holder will click
into place.
7.3
Torque Selector – only for screwing /
bit holder
Turn the Torque Selector
(10)
to select the
desired setting: the higher the number dis-
7063778-Cordless_Twin_Drill-Ma-2107-13.indb 7
7063778-Cordless_Twin_Drill-Ma-2107-13.indb 7
13-09-2021 09:29
13-09-2021 09:29
