9
English
Remove the battery before carrying out any
maintenance/cleaning of the tool.
10.1
Maintenance
There are no inner parts of the tool which
need maintenance.
10.2
Cleaning
• Keep safety devices, ventilation open-
ings and the motor housing as free as
possible from dirt and dust. Rub the
electric power tool with a clean cloth or
blow over it with low pressure com-
pressed air.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap.
Do not use any cleaning or solvent materi-
als; these can attack the device’s plastic
components. Make sure that no water can
get inside the electric power tool.
11. Technical data
Speed . . . . . . . . . . .5000 – 25000 min
-1
Chuck . . . . . . . . . . . . . . . . . . 3.2 mm
Working diameter . . . . . . . . . . Ø 25 mm
Weight. . . . . . . . . . . . . . . . . . 0.27 kg
Sound Pressure Level L
pA
. . . . 60.4 dB(A)
Uncertainty K
pA
. . . . . . . . . . . . . . . 3 dB
Sound Power Level L
WA
. . . . . . 71.4 dB(A)
Uncertainty K
WA
. . . . . . . . . . . . . . 3 dB
Hand Arm Vibration . . . . . . . . 1.289 m/s²
Uncertainty K. . . . . . . . . . . . . .1.5 m/s
2
11.1
Noise/Vibration information
Measured sound values determined accord-
ing to EN 60745.
Wear hearing protection!
Vibration total values (triax vector sum)
determined according to EN 60745:
The vibration emission level given in this
information sheet has been measured in
accordance with a standardized test given
in EN 60745 and may be used to compare
one tool with another.
It may be used for a preliminary assess-
ment of exposure.
The declared vibration emission level repre-
sents the main applications of the tool.
However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase
the exposure level over the total working
period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched off or when
it is running but not actually doing the job.
This may significantly reduce the exposure
level over the total working period.
Identify additional safety measures to pro-
tect the operator from the effects of vibra-
tion such as: maintain the tool and the
accessories, keep the hands warm, organi-
sation of work patterns.
Vibration risk limitation suggestions:
1) Wear glove during operation
2) Limit operating time and shorten trigger
time.
