Batavia 7064296, Operating Instructions Manual

English

8

WARNING: 

Never fit any attachment with a 

maximum speed lower than the no load speed 
of the machine.

Hammer Selection

•  The rotary hammer can be used in either 

hammer drill mode (for masonry work), or 
conventional rotary drill mode (for wood, 
metal, plastics etc.) with the optional pur-
chase of a standard chuck to SDS Plus 
adaptor.

•  To select rotary drilling mode, depress the 

mode selector release button 

(2)

 on the 

mode selector 

(1)

 and align the mode 

selector with the „   “  symbol.

•  To select hammer drilling mode, depress 

the mode selector release button 

(2)

 on 

the mode selector 

(1)

 and align the mode 

selector with the „ 

 “  symbol.

•  To select hammer only mode, depress the 

mode selector release button 

(2)

 on the 

mode selector 

(1)

 and align the mode 

selector with the „   “  symbol.

•  The bit angle position is intended for use 

with chipping bits such as bull points, 
spades, gouges, etc. Choose a position 
which is best suited for your operation. 
Turn the mode selector dial, to the 
„   “ symbol. Next, rotate the locking 
sleeve, along with the accessory, to the 
desired position. Then turn the mode 
selector dial to the „   “ symbol and slightly 
turn the locking sleeve to have it 
automatically lock into a definite position.

•  Do not attempt to move the mode selector 

whilst the rotary hammer is running.

OPERATING INSTRUCTIONS

IMPORTANT: 

Put on all safety equipment 

required before you operate this drill.

Trigger Switch

•  Always hold the rotary hammer firmly 

using both hands.

•  To start the rotary hammer, squeeze the 

trigger switch 

(6)

.

•  To stop the rotary hammer, release the 

trigger switch.

Selecting forward or reverse rotation

•  The direction of the drill can be changed 

using the forward/reverse switch 

(3)

.

•  To run the drill in a clockwise direction, 

position the forward/reverse switch on the 
left, adjacent to the „

►“ 

symbol.

•  To run the drill in an anti-clockwise 

direction, position the forward/reverse 
switch on the right, adjacent to the 
„

◄“ 

symbol.

•  Do not attempt to move the forward/

reverse switch whilst the rotary hammer is 
running.

•  Do not attempt to run the rotary hammer 

with the forward/reverse switch in mid 
position.

Speed Control

•  The speed of the rotary hammer is 

controlled by the pressure applied to the 
trigger switch 

(6)

. The further the trigger is 

depressed the higher the speed.

Note: 

Always read the documentation 

provided with drill bits and accessories for the 
recommended or maximum speed setting and 
use the most appropriate gear. See ‘Technical 
Data’ for the maximum no load speed of each 
gear.

Drilling Concrete

•  Using hammer drill mode, apply pressure 

to the rear of the rotary hammer, in line 
with the drill bit.

•  For efficient drilling, it is advisable to use 

TCT (tungsten carbide tipped) drill bits. 
Ensure that drill bit size is within the 
maximum capacity of the rotary hammer 
(see ‘Technical Data’).

•  Do not apply too much pressure if debris 

blocks the drill hole. Run the rotary 
hammer slowly, and remove the bit from 
the hole. Repeat until hole is cleared.

LED lamp

The LED lamp 

(9)

 will be lit automatically as 

soon as you press the ON/OFF switch 

(6)

.

ACCESSORIES

Use only accessories with an allowable speed 
matching at least the highest no-load speed of 
the tool.