Batavia MAXXPACK BT-CCG001, Operating Instructions Manual

English

6

9.  Maintenance and cleaning

WARNING: 

Always disconnect from the 

mains power supply, before carrying out any 

maintenance/ cleaning of the charger. 

Remove the battery before carrying out any 

maintenance/ cleaning of the tool.

9.1 

Maintenance

There are no inner parts of the tool which 

need maintenance.

9.2 

Cleaning

•  Keep safety devices, ventilation open-

ings and the motor housing as free as 

possible from dirt and dust. Rub the 

electric power tool with a clean cloth or 

blow over it with low pressure com-

pressed air.

•  We recommend that you clean your 

electric power tool immediately after 

each use.

•  Clean the electric power tool regularly 

with a damp cloth and somewhat soft 

soap.

Do not use any cleaning or solvent materi-

als; these can attack the device’s plastic 

components. Make sure that no water can 

get inside the electric power tool.

10. Storing

•  Clean the device before storing it.
•  Before storing check all parts for 

damages.

•  Store the device indoors in dry place 

that is protected from dust and dirt and 

extreme temperatures.

11. Technical data

Rated voltage  . . . . . . . . . . . . . 18 V DC
Cartridge size  . . . . . . . . . . max. 300 ml
Extrusion speed no load . .  max. 7.8 mm/s
Extrusion force.   .   .   .   .   .   .   . 2000–2500 Nm
Sound pressure level L

pA

 . . . .  55.22 dB(A)

Uncertainty K

pA

.   .   .   .   .   .   .   .   .   .   .   .   . 3 dB(A)

Sound power level L

WA

 . . . . .  66.22 dB(A)

Uncertainty K

WA

 . . . . . . . . . . . . 3 dB(A)

Hand/arm vibration . . . . . . . . . .0.4 m/s

2

Uncertainty K.   .   .   .   .   .   .   .   .   .   .   .   .   .1.5 m/s

2

Dimensions  . . . . . . . .23.4 × 7.2 × 43 cm
Net weight (without battery) .   .   .   .   .   1550 g
* Sound and vibration emissions may differ 

from the declared values during use 

depending on the ways in which the tool is 

used.

11.1 

Vibration level

The vibration emission level stated in this 

instruction manual has been measured in 

accordance with a standardised test given 

in EN 60745; it may be used to compare one 

tool with another and as a preliminary 

assessment of exposure to vibration when 

using the tool for the applications 

mentioned

•  using the tool for different applications, 

or with different or poorly maintained 

accessories, may significantly increase 

the exposure level

•  the times when the tool is switched off 

or when it is running but not actually 

doing the job, may significantly reduce 

the exposure level.

Protect yourself against the effects of vibra-

tion by maintaining the tool and its accesso-

ries, keeping your hands warm, and organiz-

ing your work patterns.