Batca Fitness Systems
4
AXIS Heavy Bag Hanger Owner's Manual
Step 1:
Note: Please Position Hardware in the same direction as shown in the figure. This will
make future steps easier to assemble
PLEASE FOLLOW ALL DIRECTIONS VERY CAREFULLY FOR PROPER INSTALLATION.
THE AXIS HEAVY BAG HANGER CAN BE MOUNTED IN BETWEEN ANY COMBINATION OF AT
LEAST TWO MODULAR AXIS UNITS (AXIS FREE TRAINER, AXIS BODY WEIGHT STATION, AXIS
SMITH MACHINE, OR AXIS SQUAT RACK). AT LEAST TWO MODULAR UNITS MUST BE
PURCHASED INORDER TO INSTALL AXIS HEAVY BAG SUPPORT
All Flat Washers and Nylocks are 3/8” unless otherwise noted.
Anywhere a washer is against the
round side of a tube there is to be a
3/8” CURVED WASHER
instead of a
3/8” FLAT WASHER.
Please Tighten Bolts before moving to next step.
Part #
Description
Qty
BFM-11130
Heavy Bag Frame
1
BFP-51747
SHCS 3/8” x 3”
4
BFH-50146
3/8” Flat Washer
8
BFH-50157
3/8” Nylock
4
NOTE: If you are attaching the Heavy Bag
Hanger to an AXIS Free Trainer, the front bolt
should be SHCS 3/8” x 1”. It is included in the
Hardware Blister Pack for the Heavy Bag Hanger. If
you are not attaching the Heavy Bag Anchor to an
AXIS Free Trainer then discard the SHCS 3/8” x 1”
that is included in the Hardware Blister Pack for this
station.
