Outlet
Inlet
This way up
G1/2
4.7 inch
5 inch
G1/2
1. Remove Control Box Cover
Remove all four screws in each corner of the control
box and remove the cover.
2. Remove Battery Box & Insert Batteries
Remove the battery case from the control box and
remove the screw from the center of the battery
case. Insert 4 AA batteries (batteries not included)
into the battery box ensuring they are inserted the
correct way.
3. Reinstall Battery Box & Control Box Cover
Re-install the battery box cover, matching the
alignment arrows together. Set the battery box back
into the control box, and re-assemble the control
box cover using the previously removed screws
ensuring they are all fully tightened.
Cover
Battery case
Battery Connector
Cover screws
Battery compartment
4a. Placement and Mounting Installation
Choose a location under the sink basin to mount the
control box, such that the sensor cable, flexible hose,
and incoming water supply all connect to the
control box. Under the sink basin, drill a hole
minimum 3/4” to fit the sensor cable and flexible
hose from the spout. Feed the sensor cable and
flexible hose through the hole.
Control Box Installation Instructions
Customer Service: 800-500-9895
bathselect.com
3
