BPS Freedom 50
W
S
olar
P
anel
- 5 -
The Freedom 50W Solar Panel allows you to safely and e
ffi
ciently charge
your favorite external ba eries (like the Freedom CPAP Ba ery) and other
small portable electronics (like cell phones and tablets) that operate from
13.2V or less using the power of the sun.
- 2 -
INTRODUCTION
OPTIMAL CHARGING CONDITIONS
direct sunlight with the solar panels angled toward the sun between
30° to 50° from the horizontal (
fl
at)
move the panels throughout the day to follow the movement of the sun
no clouds
no shade covering any of the solar panels
no hanging branches or other obstruc ons to direct sunlight
no dirt or debris on the solar panels
FREEDOM CPAP BATTERY CHARGING: DUAL BATTERIES
Charge mes will always vary based on the amount of power the Freedom
50W Solar Panel is able to collect from the sun, which depends upon the
amount of direct sunlight that hits the solar cells, as well as the charging
requirements of the external ba ery or portable electronic device.
In op mal charging condi ons the Freedom 50W Solar Panel can charge the
Freedom CPAP Ba ery in approximately 4 hours if the ba ery is completely
discharged. Two ba eries may be charged simultaneously but please note
that charge mes are per ba ery.
Charging a device via the DC OUT port while charging another device in the
USB OUT port at the same me will increase charge mes for both devices.
CHARGE TIMES
Unfold the Freedom 50W Solar Panel and angle it toward direct sunlight.
Open the inside
fl
ap pocket of the solar panel and remove the output
cable and set of ten (10) universal connector ps.
Plug either end of the output cable into the DC OUT port of the voltage
controller box that is built into the inside
fl
ap pocket of the solar panel.
Plug the other end of output cable into the connector p labeled “C”.
The le er “C” is embossed on the plas c por on of the p and there is a white ring
around the top metal por on of the p.
Plug the output cable with the “C” connector p a ached into the DC
power pigtail cord that was included with the Freedom CPAP Ba ery Kit.
Plug the DC power pigtail cord into the DC IN ports of both ba eries
to begin the charging process.
VOLTAGE CONTROLLER
BOX DC OUT PORT
DC POWER
PIGTAIL CORD
ROLLER
PORT
OUTPUT CABLE
“C” CONNECTOR TIP
INSIDE FLAP
DC IN PORTS
