Battipav elite 80 9000, Operating Instructions Manual

 27

Battipav srl

GB

3

To carry the machine to use a tie rod with four 

arms, capable of lifting 200 kg or at least 20% 

more than the weight of the machine, engaging 

the hooks into the carrying handles.

HANDLING

By  using  the  “transport  wheels”  accessory,  the 

machine can be moved in the yard.

CAUTION 

IN ORDER NOT TO COMPROMISE THE MACHINE 

STABILITY, KEEP STRICTLY TO THE fOLLOWING 

PROCEDURES.

HOLD THE MACHINE DURING THE WHEEL KIT 

INSTALLATION OPERATIONS.

When the machine is in working position:

a) loosen the left leg locking pin (motor side);

4

  b) lift the leg and put it in the wheel support 

c) block the leg with its locking pin

4

  d) tighten the wheel support setscrew 

e) repeat the operation for the right leg.

CAUTION 

IN ORDER TO fACILITATE THE ELITE MACHINE 

MOVEMENT IN THE YARD, WE RECOMMEND 

LOWERING IT UNTIL THE LOWERED POSITION.

a) loosen the leg locking pins on the front side, 

one at a time, holding the machine from the 

transport handles;

b) lower the machine front side, making the legs 

slide inside the supports until the leg middle 

hole matches the hole of the supports;

5

 c) lock the legs by means of the relevant leg 

locking pins;

d) repeat the operations indicated in points (a), 

(b), (c) for the rear side (motor side).

6

MOVE THE MACHINE AS INDICATED IN 

PICTURE 6

POSITIONING

Place the machine on a stabile surface.

To place the machine in working position, proceed as 

follows:

MAKE SURE THAT THE MOTOR HEAD IS LOCKED 

IN THE LOWERED POSITION BY MEANS Of THE 

LOCKING LEVER LOCATED ON THE MOTOR SIDE.

MAKE SURE THAT THE SLIDING CARRIAGE IS 

LOCKED BY MEANS Of THE CARRIAGE LOCKING 

STOPPER.

a) put the leg locking pins in release position

b) by means of the transport handles, lift the rear 

side (motor side) until the working position.

CAUTION 

fOR CORRECT MACHINE POSITIONING, MAKE 

SURE THAT THE LEG UPPER HOLE MATCHES THE 

LEG COUPLING HOLE, BEfORE fINALLY LOCKING 

IT (SEE PICTURE 8).

8

  c) lock the legs one at a time.

CAUTION 

HOLD THE MACHINE DURING THE LEG LOCKING 

PHASES.

d)  Repeat the operation for the front side.

CAUTION 

7

If THE LEGS ARE COMPLETELY REMOVED, 

PUT THEM BACK WITH THE 4 HOLES 

DOWNWARDS AND OUTWARDS.

7

7